![]() ![]() You don’t want one side higher than the other. You want both sides of front at same level as each other. For example, you may want 8 inches at the rear and 7 ½ inches at the front. You don’t want the same measurement for the front and rear. This means the truck has maximum rake, where the front is lower than the rear.ĭecide how high you want to raise the front. If you find the bolt loosened all the way down, it is de-adjusted completely. The lever is attached to the torsion bar leading to the front control arm. You’ll find this bolt attached to a lever. You will have to tighten the bolt on the torsion bar to adjust the rake. The adjustment area is behind the transfer case on most pickup trucks. Lift it from the frame so suspension can hang. Lift the Front of the Truck Up from the Frame.Torsion Bar Adjustment Tips: How to Adjust the Torsion Bars Yourself Properly What Is a Torsion Bar? Check all four tires and compare measurements. With a tape measure, you can also measure the distance from the tire to the wheel well. Place a leveler on the bed rail to see how well your vehicle balances. If you hit a bump, you might lift the front of the truck off the ground and lose traction. If you find that the truck is level or lower in the rear, you’ll have issues with steering and braking, especially around corners. To find out how much the vehicle sags, fully load it up and take a measurement so you know how much sag there is in relation to the front. How Can I Measure My Vehicle’s Rake? Measuring a truck’s rake with a leveler and tape measurer If you tend to lug heavy objects and tow, you’ll want more rake than if you use your truck more as a daily driver without doing a lot of heavy lifting that will weigh the back down. Decide how much rake you want depending on how you use your vehicle. You can adjust the rake with the torsion bars. Torsion bar adjustment bolt that is completely de-adjusted ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |